Canon imagerunner C5180 Service Manual page 721

Chapter 19
INTROT-2 Sets the execution interval (number of sheets) for image stabilization control (adjustment set 2) during
forward/reverse operation. Sets the interval in which automatic adjustment control (adjustment set 2)
is performed during forward/reverse operation of copy or print jobs.
Reference:
If this item is set to a smaller value than the setting value for image stablization control (adjustment
set 1) (COPIER > OPTION > BODY > INTROT-1), the setting value for this item is invalid.
The count is reset in the following cases:
- When the number of sheets reaches the specified value
- When an image stablization control process including the control items performed by this item is
performed
Increasing the interval in which the control process is performed may adversely affect the density
fluctuation.
When the setting value for the COPIER > OPTION > BODY > ADJ-LVL item is 2, the setting for
this item is invalid.
Setting values 50 to 1000
[Factory default/After RAM clear: 500]
INTROT-T Sets the execution interval (time) for image stabilization control during standby.
Sets the interval in which image stabilization control is performed during standby.
The control process is performed after the preset amount of time has elapsed since the last job was
performed.
Reference:
The time count starts after the last job has finished. The time is reset in the following cases:
- When the time reaches the specified value
- When a job is received before the time has reached the specified value
To turn image stabilization control during standby ON/OFF, select:
COPIER > OPTION > BOD > AUTO-DH
Setting values 1 to 10 (hours)
[Factory default/After RAM clear: 2]
DEVL-PTH Sets threshold value (number of sheets) for starting toner forcible consumption sequence.
Use this item when copying/printing consecutive images with low color ratios. Operation method If
the density drops below the set threshold value when copying/printing method consecutive low-color-
ratio images, once the set number of sheets has been exceeded, the toner forcible consumption
sequence is started during the job.
Setting values
0: Don't perform sequence
1: About 100 sheets
2: About 200 sheets [Factory default/After RAM clear: 2]
3: About 500 sheets
AUTO-DH Turns image stabilization control OFF/ON during standby.
Used to turn OFF/ON the image stabilization control operation started by fluctuation in environment
during standby, or started after the copier has been idle for an extended period.
Operation method Downtime not intended by the user (when the copier starts up by itself) can be
eliminated by turning OFF the image stabilization control operation that starts automatically due to
environmental fluctuation during standby or when the copier is idle for an extended period.
Setting values
0: Automatic start OFF (prohibit operation)
1: Automatic start ON (permit operation)
Reference:
The trigger time setting (in hours) is set by the following service mode item:
COPIER > OPTION > BODY > INTROT-T
If you enter a setting value of 0 (OFF), the user will have to monitor the output image to determine
when to perform the following item in the user mode:
Adjustment/cleaning > automatic gradation compensation (full compensation).
Other image stabilization control p
DFDST-L1 A higher setting will increase the level of dust detection (i.e., the machine will be more sensitive in
detecting dust, which if left behind will cause thin lines in the images).
settings range
0 to 255
[Factory default/After RAM clear: 200]
19-76
COPIER>OPTION>BODY
1
1
1
1
1