Drum Unit Drive Belt - Canon imagerunner C5180 Service Manual

Chapter 12

12.5.39 Drum Unit Drive Belt

12.5.39.1 Preparation for Removing the
Drum Unit Drive Belt
1) Remove the upper left cover.(page 12-
21)Reference[Removing the Upper Left Cover]
2) Remove the lower left cover.(page 12-
21)Reference[Removing the Left Lower Cover]
3) Remove the rear left cover (upper side).(page 12-
23)Reference[Removing the Rear Left Cover
(Upper)]
4) Remove the developing drive unit.(page 12-
27)Reference[Removing the Developing Drive
Unit]
5) Remove the lattice connector mount [4].
- 2 clamps [1]
- 2 screws [2]
- 6 connectors [3]
[2]
[4]
[1]
F-12-134
6) Remove the high voltage unit 2.(page 12-
28)Reference[Removing the High-Voltage Unit
2]
12-58
[3]
[3]
[3]
[3]
[3]
[2]
7) Remove drum ITB motor base [3].
- 2 connectors [1]
- 3 screws [2]
[2]
[1]
[2]
[1]
F-12-135
Points to Note When Removing the Drum
ITB Motor Mounting
To remove, put your hand into the inside where you
have slid out the manual feed unit; then, while
holding down the swing plate [1] found to the rear of
the drum drive unit, remove from the machine's rear
side plate.
The drum drive unit is hooked on the protrusion from
the rear side plate; lift it slightly to detach.
F-12-136
[3]
[2]