Table of Contents
Advertisement
Chapter 11
5) Remove the protective cover [2] on the rear side
of the fixing unit.
- 3 screws [1]
[2]
1]
F-11-40
6) Remove the harness from the harness guide [2].
- 2 connectors [1]
[2]
[1]
F-11-41
11-38
7) Remove the harness guide [1]. (Shift it to the side,
and pull it off the pin to detach.) The removed
harness guide will be used during mounting work.
[1
8) Mount the fixing unit using the steps used to
remove it but in reverse.
Points to Notes at Replacing/Disposing the
Fixing Unit
The heat pipe is used at the upper belt of the fixing
unit to even the heat at the rear front direction. The
heat pipe is a part that the small amount of liquid is
vacuum-encapsulated in the airtight container. Thus,
do not throw the heat pipe in the fire because it will
burst. When disposing the fixing unit, be sure to
shred.
[1]
F-11-42
Advertisement
Chapters
Table of Contents
