Chapter 10
21) Remove the duplexing driver PCB [2].
- 4 Screws [1]
F-10-226
10.10.43.2 Removing the Duplex Pickup
Sensor
1) Remove the rail support plate [2] of the manual
feed unit.
- 2 screws [1] from the rear side plate side
F-10-227
10-88
2) Remove the rail guide [3] of the manual feed unit
as shown.
- 3 screws [1] from the side of the rear side plate
- 3 screws [2] from the side of the front side plate
F-10-228
3) Remove the drawer connector support plate [2].
- 2 screws [1]
F-10-229