Chapter 10
10.10.24 Pre-Registration Motor
10.10.24.1 Preparation for Removing the
Pre-Registration Motor
1) Remove the manual feed unit. (page 10-
52)Reference[Removing the Manual Feed Unit]
2) Remove the manual feed unit cover. (page 12-
28)Reference[Removing the Manual Feed Unit
Cover]
3) Remove the motor cover.
3-1) Remove the motor cover [2] at the rear.
- screw [1]
[1]
F-10-127
10.10.24.2 Removing the Pre-Registration
Motor
1) Remove the pre-registration motor [3].
- connector [1]
- 2 screws [2]
[2]
[1]
[3]
F-10-128
When mounting the registration motor, be sure that
the belt is fitted to the gear of the motor shaft.
10-60
[2]
[2]
10.10.25 Horizontal Registration
Motor
10.10.25.1 Preparatiuon for Removing the
Horizontal Registration Motor
1) Remove the fixing unit.
1-1) Remove the fixing drive unit.(page 11-
38)Reference[Removing the Fixing Drive
Unit]
1-2) Remove the fixing unit.
2) Remove the fixing/feeder unit.(page 10-
63)Reference[Removing the Fixing/Feeder Unit]
3) Lift the duplexing open/close guide [3] in the
direction of [A] and shift it in the direction of [B].
Then, remove it.
- 1 connector [2] (Open sheet [1].)
[A]
[B]
[1]
[2]
F-10-129
[3]