Canon imagerunner C5180 Service Manual page 489

Chapter 11
11.5.17.2 Removing the Fixing Belt
Displacement Control Motor Unit
Points to Note When Removing the Fixing
Belt Displacement Control Motor Unit
In the case of removing the fixing belt displacement
control motor unit, make sure to remove only the
parts described in the following steps to remove. Do
not remove other parts such as the sensor and the
flag. Because the sensor position and the flag
position are fine adjusted in the factory, it will be
difficult to adjust in the field if removing these parts.
1) Move the pressure belt displacement control
motor unit [4] in the direction of the arrow to
detach the cover [3].
- 1 E-ring [1]
- 1 screw [2]
[3] [1]
F-11-89
2) Along with the gear [1] and the 2 bearings [2],
remove the pressure belt displacement control
motor unit [4] from the shaft [3].
11-52
[4]
[2]
[1]
[4]
F-11-90
3) From the shaft [4] of the fixing belt displacement
control motor unit [5], remove the E-ring [1], the
gear [2], and the 2 bearings [3]. This fixing belt
displacement control motor unit [5] (the unit that
the E-ring, the gear, and the 2 bearings are
removed) is to be a service part.
[2]
[3]
[1]
F-11-91
[3]
[2]
[5]
[4]
[3]