Fitting The Secondary Transfer Outside Roller Unit In Place - Canon imagerunner C5180 Service Manual

Chapter 2
8) Hold the protective cover [2] horizontally, and
push in the drum unit (Y) [2]. (starting from the left,
Y, M, C, and Bk)
Store away the protective cover [1], as it will be used
when fitting the drum unit in place.
[2]
F-2-43
9) Pull out the sealing tape [1].
When pulling out the sealing tape [1], be sure to hold
the drum unit in place to avoid inadvertently sliding
out the drum unit.
[1]
F-2-44
10) Fit the remaining drum units in the same way (M,
C, Bk).
11) Close the drum unit cover; then, turn the open/
close lever to the right by 90 deg to fix it in place.
2-18
[1]
12) Holding the waste toner box in place, shift the
intermediate transfer unit release lever back into
its initial position.
F-2-45
13) Close the front cover.
2.2.6 Fitting the Secondary Transfer
Outside Roller Unit in Place
1) Take out the secondary transfer outside roller unit
from the packaging box.
Do not touch the roller of the secondary transfer
outside roller unit.
2) Pull on the fixing release lever [1] to fully slide out
the fixing feeding unit [2].
[2]
F-2-46
3) Hold the pick [1] of the secondary transfer outside
roller, and place it on the secondary transfer unit
[2]
[1]
[1]