Chapter 12
2.2. Optional Sub Power Supply PCB
Output Name
All-night/Non-all-night
Non-all-night
Tolerance
12.4.3 Protection Function
12.4.3.1 Protective Mechanisms
The machine's power supply PCB and the power supply PCBs of its accessories are equipped with an
overcurrent/voltage protective mechanisms that prevent damage to the power supply circuit by automatically
cutting off the output voltage in the event of an overcurrent/voltage caused, for example, by a short-circuit in
any of its loads.
If the protective function has gone ON, turn off the power switch of the printer unit, disconnect the power plug
of the printer unit or the accessories power supply circuit, and remove the cause of activation; then, leave the
machine alone for about 3 min, and turn it on to reset.
12.4.4 Backup Battery
12.4.4.1 Battery for Backup
The SRAM PCB located at the main controller PCB and the DC controller PCB 1(IMG) of this machine are
equipped each 1 of lithium battery as a backup power supply for each data in the case when there is blackout or
the power plug is disconnected
SRAM PCB
DC controller PCB
Life of the Battery
Replacement of the Battery Replacement of the battery itself is not available in the servicing field.
Remedy after replacement
of the battery at the
workshop
Wenn mit dem falschen Typ ausgewechselt, besteht Explosionsgefahr.
Gebrauchte Batterien gemas der Anleitung beseitigen.
12-14
T-12-9
Non-all-night
Manganese Dioxide/Lithium Battery (3V, 100mAh)
Lithium Battery (3V, 560mAh)
10 years or more for both batteries (the state that the power plug is disconnected)
Enter the value indicated on the service label
5VA
Non-all-night
5V
+/-5V
24VA
24Çu
+7/-5%