Table of Contents
Advertisement
Chapter 5
-Control Program 2 (interval 3)
1. The individual software modules are initialized, and the printer and screen configurations are established.
2. The start-up sequence ends when the printer and scanner are correctly recognized. Otherwise, an error code
(E732/E733) will be indicated at the end of a connection time-out.
The engine becomes ready to accept a job when the start-up sequence ends normally. (Its control panel displays
the control screen, and the Start key LED changes from red to green.)
3
1
2
F-5-6
5-6
Advertisement
Chapters
Table of Contents
