Table of Contents
Advertisement
Chapter 12
When Attaching the DC Controller PCB
Cover
When attaching the cover, take care so that the cut-
off will not come into contact with the latch of the
flat cable. Otherwise, the flat cable can come loose.
[1]
F-12-87
7) Remove the DC controller mounting.
7-1) Remove all connectors from the PCB, and free
all harnesses from the cable clamps; then,
remove the 7 screws [1], and remove the DC
controller PCB [2] together with its base.
F-12-88
12-44
12.5.24.2 Removing the Front Cover
Open/Closed Sensor
1) Remove the sensor flag retaining plate [2] found
at the front.
- 1 screw [1]
F-12-89
2) Pull out the sensor mounting plate [3] (The sensor
flag retaining plate is found between the front side
plate and the rear side plate).
- 2 connectors [1]
- 2 screws [2]
F-12-90
[1]
[2]
Advertisement
Chapters
Table of Contents
