Canon imagerunner C5180 Service Manual page 713

Chapter 19
Sub item
LANG-ERR Clear language related error.
This item enables recovery when a language related error code is generated after switching from
the default language. (Returns to default language after recovery.)
ERDS-DAT Embedded-RDS SRAM data clear
SCM data in the embedded-RDS SRAM are restored to the factory settings.
SND-STUP - use it to initialize the transmission read settings
After changing service mode settings (pressing the OK key), turn off and then on the power to
initialize the backup data of the transmission read settings.
Otherwise, after you have changed the display language, the language used before the change
would remain. Be sure to perform this mode item if you have switched the language.
CA-KEY CA authentication and key deleted together.
When the serviceman needs to replace or dispose of the device, the CA authentication and key
can be deleted together.
KEY-CLR HDD encoding board code key clear
The HDD encoding board (security kit) code key is cleared to allow replacement.
When this item is selected and OK pressed, the code key is cleared. Then, when the main power
supply is turned OFF/ ON, the encoding board installation processing activates. If installation
processing is carried out, a new code key is generated.
Caution!
If this operation is carried out, all data on the HDD will be rendered useless. The main power
supply is switched OFF/ ON after this operation in order to format the HDD.
10. MISC-R
Sub item
SCANLAMP Use it to check the activation of the scanning lamp.
Method of Operation
1) Select the item.
2) Press the OK key so that the scanning lamp will go on and remain on for 3 sec.
19-68
COPIER>FUNCTION>CLEAR
Description
T-19-54
COPIER>FUNCTION>MISC-R
Description
level.
1
1
2
2
2
level.
1