Canon imagerunner C5180 Service Manual page 711

Chapter 19
9. CLEAR
Sub item
ERR Clears error codes.
(Cleared error codes: E000, E001, E002, E003)
Operation method
1) Select this item, and press the OK key.
2) Turn the main power OFF/ON.
DC-CON Clears DC controller PCB's RAM.
The RAM is cleared after the main power switch is turned OFF/ON.
Operation method
1) Select COPIER > FUNCTION > MISC-P > P-PRINT to print out the service mode setting
values.
2) Select this item, then press the OK key.
3) Turn the main power OFF/ON.
4) Enter the data printed by the P-PRINT operation as needed.
R-CON Use it to reset the RAM on the reader controller PCB.
Method of Operation
The RAM will not be cleared until the main power switch has been turned off and then on again.
2) Select the item, and press the OK key.
3) Turn off and then on the main power.
4) As necessary, enter the settings printed out using 'PRINT'.
JAM-HIST Clears reader controller PCB's RAM.
The RAM is cleared after the main power switch is turned OFF/ON.
Operation method
1) Select COPIER > FUNCTION > MISC-P > P-PRINT to print out the service mode setting
values.
2) Select this item, then press the OK key.
3) Turn the main power OFF/ON.
4) Enter the data printed by the P-PRINT operation as needed.
ERR-HIST Clears error code history.
The error code history is cleared after the main power switch is turned OFF/ON.
Operation method
1) Select this item, then press the OK key.
2) Turn the main power OFF/ON.
PWD-CLR Clears "System administrator" password set in user mode.
The password value is cleared after the main power switch is turned OFF/ON.
Operation method
1) Select this item, then press the OK key.
2) Turn the main power OFF/ON.
ADRS-BK Clears address book data.
The address book data is cleared after the main power switch is turned OFF/ON.
Operation method
1) Select this item, then press the OK key.
2) Turn the main power OFF/ON.
19-66
T-19-53
COPIER>FUNCTION>CLEAR
Description level.
1
1
1
1
1
1
1