Manual Feed Unit Open/Closed Detecting Switch - Canon imagerunner C5180 Service Manual

Chapter 12
2) Remove 2 terminals [1].
3) Pick up the stopper [A], and remove the main
power switch [2].
[A]
[2]
F-12-95
12.5.26 Manual Feed Unit Open/
Closed Detecting Switch
12.5.26.1 Preparation for Removing the
Manual Feed Unit Open/Close Switch
1) Remove the rear upper cover.(page 12-
22)Reference[Removing the Rear Upper Cover]
2) Remove the rear lower cover.(page 12-
23)Reference[Removing the Rear Lower Cover]
3) Remove the left rear cover (upper).(page 12-
21)Reference[Removing the Left Rear Cover
(Upper)]
4) Remove the controller box cover.
4-1) Remove the main controller cover [4].
- 1 connector J1512 [1] from the power
distribution PCB
- harness from the wire saddle [2]
- 6 screws [3]
12-46
[1]
[A]
F-12-96
5) Remove the DC controller PCB cover [2].
(Referring to procedure 12.5.24.1)
6) Open the main controller box
6-1) Remove the 2 flat cables [1] used to connect the
DC controller PCB and the main controller
PCB.
F-12-97