Canon imagerunner C5180 Service Manual page 732

MIX-FLG Use it to select an image field flag (for image synthesis).
Selects the image processing method which is performed when a combined image cannot be
compressed at a certain compression ratio on the main controller side.
Setting value
0: Image processing equivalent to the PDL character mode
1: Image processing equivalent to the PDL photo mode
2: Image processing equivalent to the SCAN character mode
3: Image processing equivalent to the SCAN photo mode
[Factory default/After RAM clear: 0]
KSIZE-SW Paper size (K size) switch for China
*2 This switch allows iR series scanner controllers to support K size paper detection and display.
When the switch is set to ON = 1 for MODEL-SZ = (AB type) destinations, the operation switches to
allow K size paper recognition and detection to be performed with document detection, paper
selection screen and APS type, etc. The following types of K size paper are available.
- 8K: 270mm x 390 mm
- 16K: 270mm x 195 mm
Setting values
0: OFF (K size paper not handled)
1: ON (K size paper handled)
[Factory settings and after RAM clear: 0]
LPD-PORT Toggle switch to turn Rx transfer (PDF Tx) reduction transmission ON/ OFF.
Images received in FAX, IFAX modes are converted to PDF and then reduced for transmission as
email or for file transmission.
Setting range
1 to 65535
[Factory settings and after RAM clear: 515]
ORG-A4R Sets special paper sizes in ADF.
Sets special paper sizes that cannot be detected in the ADF.
Setting values
0: A4R
1: FOLIO-R
[Factory settings and after RAM clear: 0]
PDF-RDCT Switches to reduction transmission for reception transfer (PDF transmission).
Images received in FAX, IFAX modes are converted to PDF and then reduced for transmission as
email or for file transmission.
Setting values
0: Image not converted to PDF and reduced for reception transfer.
1: Image converted to PDF and reduced for reception transfer.
[Factory settings and after RAM clear: 0]
REDU-CNT Switching control for density adjustment method
Controls whether to perform density adjustment, in consideration of the amount of toner deposit.
REBOOTS Reboot switch for E240 error
W Sets whether to reboot automatically when an E240 error occurs.
Setting values
0: Automatic reboot when E240 occurs.
1: No automatic reboot when E240 occurs.
[Factory settings and after RAM clear: 0]
How to use:
There have been complaints from the field that, if the unit reboots automatically when E240 occurs,
PDL jobs are lost. This item has been added in order to enable selection of whether to reboot
automatically or not.
COPIER>OPTION>BODY
Chapter 19
2
2
2
2
2
2
2
19-87