Isdn Progress-Indicator - HP MSR series Command Reference Manual

Default command level
2: System level
Parameters
window-size: Sliding window size in the range of 5 to 64.
Examples
# Configure the sliding window size on interface CE1/PRI 1/0 as 10.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-E1 1/0] using ce1
[Sysname-E1 1/0] pri-set
[Sysname-E1 1/0] quit
[Sysname] interface serial 1/0:15
[Sysname-Serial1/0:15] isdn pri-slipwnd-size 10

isdn progress-indicator

Use isdn progress-indicator to set the progress indicator value in the ISDN signaling messages sent by
an ISDN interface.
Use undo isdn progress-indicator to restore the default.
Syntax
isdn progress-indicator indicator
undo isdn progress-indicator [ indicator ]
Default
The progress indicator value set by the upper-layer voice service applies.
Views
ISDN interface view
Default command level
2: System level
Parameters
indicator: Specifies one of the progress indicators in
Table 17 Progress indicator values
Value
1
2
3
4
5
8
Description
Call is not end-to-end ISDN; further call progress information may be available in-band.
Destination address is non-ISDN.
Origination address is non-ISDN.
Call has returned to the ISDN.
Interworking has occurred and has resulted in a telecommunication service change.
In-band information or an appropriate pattern is now available.
Table 17.
92