Isdn Two-Tei - HP MSR series Command Reference Manual

# After a moment, stop collecting statistics about message receiving and sending on CE1/PRI interface
Serial 1/0:15.
[Sysname-Serial1/0:15] isdn statistics stop
# Display statistics about message receiving and sending on CE1/PRI interface Serial 1/0:15.
[Sysname-Serial1/0:15] isdn statistics display
ISDN Statistic Status: Stopped
ISDN layer 3 message received and sent out on current port:
CALL_PROC
SETUP
CONN
SETUP_ACK
CONNECT_ACK
DISCONNECT
RELEASE
RELEASE_COM

isdn two-tei

Use isdn two-tei to configure the BRI interface to request the connected switch for a new TEI value before
calling for a B channel.
Use undo isdn two-tei to restore the default.
Syntax
isdn two-tei
undo isdn two-tei
Default
All the B channels on the BRI interface use one TEI value.
Views
ISDN BRI interface view
Default command level
2: System level
Usage guidelines
This command applies in the situation where the switch with which the router works is an ISDN NI
compliant switch (the DMS100 for example) in North America. You must make sure the TEI value
assigned to each B channel is unique to ensure a successful MP channel call. Otherwise, only one B
channel can be brought up and calling for MP fails.
Examples
# Configure interface BRI 2/0 to request the connected switch for a new TEI value before calling to bring
up a B channel.
<Sysname> system-view
[Sysname] interface bri 2/0
[Router-Bri2/0] isdn two-tei
Send(0)
Send(6)
Send(13)
Send(0)
Send(5)
Send(3)
Send(1)
Send(18)
Recv(6)
Recv(13)
Recv(5)
Recv(6)
Recv(13)
Recv(16)
Recv(18)
Recv(1)
103