Dlsw Local - HP MSR series Command Reference Manual
Layer 2 wan
Hide thumbs
Also See for MSR series:
- Configuration manual (889 pages) ,
- Command reference manual (684 pages) ,
- Wan access configuration manual (293 pages)
Table of Contents
Advertisement
Parameters
circuit-weight: Default virtual circuit weight, which is used by the remote peers that are not explicitly
configured with the virtual circuit weight. The value range for the circuit-weight argument is 1 to 100, and
the default is 10. A remote peer with a bigger virtual circuit weight will be assigned more virtual circuits.
Default
DLSw load balancing is disabled.
Examples
# Enable DLSw load balancing, and set the default virtual circuit weight to 20.
<Sysname> system-view
[Sysname] dlsw load-balance circuit-weight 20
dlsw local
Use dlsw local to create a local DLSw peer.
Use undo dlsw local ip-address to remove the specified local DLSw peer.
Use undo dlsw local ip-address { init-window | keepalive | keepcount | max-frame | max-window |
permit-dynamic } * to restore the default parameters.
Syntax
dlsw local ip-address [ init-window init-window-size | keepalive keepalive-interval | keepcount
keepcount-number | max-frame max-frame-size | max-window max-window-size | permit-dynamic |
vendor-id vendor-id ] *
undo dlsw local ip-address [ init-window | keepalive | max-frame | max-window | permit-dynamic ]
*
Views
System view
Default command level
2: System level
Parameters
ip-address: IP address of the local peer to be created. This IP address must be reachable.
init-window-size: Initial local window size in the range of 1 to 2000. The default is 40 (frames).
keepalive-interval: Interval between keepalive messages, in seconds. The range is 0 to 1200, and the
default is 30 seconds. A value of 0 indicates that no keepalive message will be sent.
keepcount-number: Number of keepalive messages transmitted, in the range of 1 to 30 and defaulting
to 3. When the number of sent keepalive messages reaches keepcount-number but no response is
received from the remote DLSw peer, the local DLSw entity disconnects the connection.
max-frame-size: Maximum frame size in bytes. The value can be 516, 1470, 1500, 2052, 4472, 8144,
1 1407, 1 1454, and 17800, and the default is 1500.
max-window-size: Maximum local window size in the range of 1 to 2000. The default is 50 (frames).
permit-dynamic: Permits non-peer routers to initiate connections to establish peering relationships
dynamically with this router. For a local peer created by using the command with the keyword specified,
you do not need to configure a remote peer.
255
Advertisement
Table of Contents
