Ppp Ipcp Remote-Address Forced - HP MSR series Command Reference Manual

Syntax
ppp ipcp dns request
undo ppp ipcp dns request
Default
A device does not request its peer for the DNS server IP address actively.
Views
Interface view
Default command level
2: System level
Usage guidelines
Suppose a device is connected to another device through PPP, for example, a device is connected to the
operator's access server through a dial-up link. In this case, you can configure a device to request its peer
for the DNS server IP address during IPCP negotiation, so that the device can resolve domain names
through the DNS server specified by the peer.
You can check the DNS server IP addresses of a port by displaying information about the port.
Examples
# Enable the device to request its peer for the DNS server IP address actively through interface Serial
2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ppp ipcp dns request

ppp ipcp remote-address forced

Use ppp ipcp remote-address forced to configure a device to assign an IP address to the peer by force.
This command also disables the peer from using a locally configured IP address.
Use undo ppp ipcp remote-address forced to cancel the configuration.
Syntax
ppp ipcp remote-address forced
undo ppp ipcp remote-address forced
Default
The peer is allowed to use its locally configured IP address. The local end assigns an IP address to the
peer only when being explicitly requested to do so. When the peer has already an IP address, the local
end will not assign one to the peer.
Views
Interface view
Default command level
2: System level
11