Display Ppp Mp - HP MSR series Command Reference Manual

Description: Virtual-Template1 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet Address is 6.1.1.2/8 Primary
Link layer protocol is PPP
LCP initial, MP opened
Physical is None, baudrate: 100000000 bps
Output queue : (Urgent queuing : Length)
Output queue : (Protocol queuing : Length)
Output queue : (FIFO queuing : Length)
Last clearing of counters:
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
512 packets input, 43008 bytes, 0 drops
614 packets output, 49636 bytes, 0 drops
# Display brief information about VT 1.
<Sysname> display interface virtual-template 1 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
VT1
See Table 1
Related commands
interface virtual-template

display ppp mp

Use display ppp mp to display information about an MP interface.
Syntax
display ppp mp [ interface interface-type interface-number ] [ | { begin | exclude | include }
regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
Never
Link Protocol Main IP
UP UP(s)
for the output description.
100
500
75
Description
--
25