Fr Dlci-Switch - HP MSR series Command Reference Manual

Views
Interface view
Default command level
2: System level
Parameters
dlci-number: Assigns a virtual circuit to the frame relay interface, in the range 16 to 1007. The range 0
to 15 and 1008 to 1023 are reserved for special purposes.
Usage guidelines
A virtual circuit number is unique on a physical interface.
On a DCE or NNI frame relay main interface or subinterface, you must manually create the virtual
circuits.
On a DTE main interface, the device automatically creates virtual circuits according to the settings
received from the DCE side. If you do that manually, make sure that the DLCIs of the virtual circuits are
identical to those used on the DCE.
On a DTE subinterface, you must manually create the virtual circuits.
Examples
# Assign a virtual circuit with DLCI 100 to frame relay interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] fr dlci 100
[Sysname-fr-dlci-Serial2/0-100]

fr dlci-switch

Use fr dlci-switch to configure a static route for frame relay PVC switching.
Use undo fr dlci-switch to delete a static route for frame relay PVC switching.
Syntax
fr dlci-switch in-dlci interface interface-type interface-number dlci out-dlci
undo fr dlci-switch in-dlci
Default
No static routes are configured for frame relay PVC switching.
Views
Frame relay interface view, MFR interface view
Default command level
2: System level
Parameters
in-dlci: DLCI in the packets received on the interface, in the range 16 to 1007.
interface interface-type interface-number: Specifies an interface by its type and number.
dlci out-dlci: Specifies the DLCI carried in the packets sent, in the range 16 to 1007.
118