Ipv6 Ind Holdtime - HP MSR series Command Reference Manual

Default
IND is disabled.
Views
Interface view
Default command level
2: System level
Parameters
dlci-number: Enables IND for the virtual circuit specified by its DLCI number in the range of 16 to 1007.
Usage guidelines
FR uses an address mapping to map a local DLCI number to a peer address. Address mappings can be
configured manually, or automatically through IND (IND).
Use this command to enable IND.
To enable or disable IND for all virtual circuits on an interface, use the command without any parameter.
To enable or disable IND for a virtual circuit, use the command with the dlci-number argument.
Enabling IND on an interface or subinterface also enables IND on all the virtual circuits of the interface
or subinterface. To disable IND on a specific virtual circuit of the interface or subinterface, use the undo
fr ipv6 ind dlci-number command.
Disabling IND on an interface with the undo fr ipv6 ind command also disables IND on all the virtual
circuits on the interface. To enable IND for a specific virtual circuit of the interface, use the fr ipv6 ind
dlci-number command.
The fr ipv6 ind command configured on an FR main interface also applies to its subinterfaces.
Examples
# Enable IND for all virtual circuits on the FR interface Serial2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] fr ipv6 ind

ipv6 ind holdtime

Use ipv6 ind holdtime to set the interval for sending IND solicitations.
Use undo ipv6 ind holdtime to restore the default.
Syntax
ipv6 ind holdtime seconds
undo ipv6 ind holdtime
Default
The interval is 30 seconds.
Views
Interface view
159