Oam Frequency - HP MSR series Command Reference Manual

Parameters
up up-seconds: Specifies that the PVC goes up if no AIS/RDI alarm cells are received in a period
specified by the up-seconds argument (in seconds). The value range for the up-seconds argument is 3 to
60, and the default is 3.
down down-count: Specifies that the PVC goes down when the number of successive AIS/RDI alarm cells
received reaches the value specified by the down-count argument. The value range for the down-count
argument is 1 to 60, and the default is 1.
Usage guidelines
The oam ais-rdi command is not applicable to the secondary PVCs of a PVC group.
The primary PVC of a PVC group is the PVC based on which the PVC group is created.
Second PVCs are created in PVC groups.
Examples
# Set the AIS/RDI alarm detection parameters for PVC 1/32, setting up-seconds to 10, and down-count
to 5.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] pvc 1/32
[Sysname-atm-pvc-Atm1/0-1/32] oam ais-rdi up 10 down 5

oam frequency

Use oam frequency to enable the transmission and retransmission detection of the OAM F5 Loopback
cell, as well as to modify the related parameters.
Use undo oam frequency to disable the transmission and retransmission detection of the cell.
Syntax
oam frequency frequency [ up up-count down down-count retry-frequency retry-frequency ]
undo oam frequency
Default
OAM F5 Loopback cell transmission is disabled, but if an OAM F5 Loopback cell is received, it should
be responded.
Views
PVC view, ATM class view
Default command level
2: System level
Parameters
frequency: Interval (in seconds) at which OAM F5 loopback cells are sent. The value range is 1 to 600.
up up-count: Specifies that the PVC goes up when the number of successive OAM F5 loopback cells
received correctly reaches the value specified by the up-count argument. The value range for the up-count
argument is 1 to 600, and the default is 3.
222