Dialer-Group - HP MSR series Command Reference Manual

undo dialer user [ username ]
Default
No remote username is set.
Views
Dialer interface view
Default command level
2: System level
Parameters
username: Remote username for PPP authentication, a string of 1 to 80 characters.
Usage guidelines
This command is only valid on dialer interfaces in RS-DCC.
On a dialer interface encapsulated with PPP, DCC identifies which dialer interface is to be used for
receiving calls based on the remote username obtained through PPP authentication.
You can configure multiple dialer users (up to 255) on a dialer interface. This allows DCC to provide
accesses to multiple dialup interfaces by using one dialer interface.
Use this command on a C-DCC enabled dialer interface with caution. It enables RS-DCC and can
remove the C-DCC configurations on the interface.
Performing the undo dialer user command on a dialer interface can clear all configurations on it.
Examples
# Add a remote username routerb.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer user routerb
Related commands
ppp pap local-user
•
• ppp chap user

dialer-group

Use dialer-group to assign the interface to a dialer access group.
Use undo dialer-group to remove the interface from the dialer access group.
Syntax
dialer-group group-number
undo dialer-group
Views
Dialup interface (physical or dialer interface) view
Default command level
2: System level
179