Parameters
interface interface-type1 interface-number1: Specifies an interface by its type and number. It can only be
a Layer 3 Ethernet interface, Ethernet subinterface, or VLAN interface.
interface-type2 interface-number2: Specifies an interface by its type and number. It can only be a
synchronous serial interface, MP group interface, POS interface, or POS subinterface.
ip-address ip-address1: Specifies a remote IP address of the interface specified by interface-type1
interface-number1.
ip-address2: Specifies a remote IP address of the PPP interface specified by interface-type2
interface-number2. It must be located on the same network segment as ip-address1.
Examples
# Create an EtoPPP translation mapping to map Ethernet 1/1 to Serial 2/0.
<Sysname> system-view
[Sysname] etoppp translate interface ethernet 1/1 serial 2/0 ip-address 1.1.1.1 1.1.1.2
Related commands
display etoppp translate
reset etoppp translate
Use reset etoppp translate to clear the translation statistics for the EtoPPP translation entry for the
specified interface or all EtoPPP translation entries if no interface is specified.
Syntax
reset etoppp translate [ interface interface-type interface-number ]
Views
User view
Default command level
1: Monitor level
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. It can only be a
Layer 3 Ethernet interface, Ethernet subinterface, or VLAN interface.
Examples
# Clear the translation statistics for the EtoPPP entry for interface Ethernet 1/1.
<Sysname> reset etoppp translate interface ethernet 1/1
Related commands
display etoppp translate
EtoFR configuration commands
display etofr translate
Use display etofr translate to display EtoFR translation entries and translation statistics.
324