X25 Vc-Per-Map - HP MSR series Command Reference Manual
Layer 2 wan
Hide thumbs
Also See for MSR series:
- Configuration manual (889 pages) ,
- Command reference manual (684 pages) ,
- Wan access configuration manual (293 pages)
Table of Contents
Advertisement
Usage guidelines
According to X.25, a timer should be started when a DTE sends a clear request (or a DCE sends a clear
indication). If no peer acknowledgement is received after the timer timeout, the sending end will take
some measures to guarantee the normal proceeding of the local procedure.
Examples
# Set the clear timer to 100 seconds on the X.25 interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer tx3 100
Related commands
x25 timer tx0
•
x25 timer tx1
•
•
x25 timer tx2
x25 vc-per-map
Use x25 vc-per-map to set the maximum number of VCs for connections with the same destination
device.
Use undo x25 vc-per-map to restore the default.
Syntax
x25 vc-per-map count
undo x25 vc-per-map
Default
The maximum number of VCs for connections with the same destination device is 1.
Views
Interface view
Default command level
2: System level
Parameters
count: Maximum number of VCs, in the range of 1 to 8.
Usage guidelines
If the parameter is greater than 1, and the sending window and the sending queue of virtual circuit are
filled full, the system will create a new virtual circuit to the same destination. If the new virtual circuit
cannot be created, packets will be discarded.
Examples
# Set the maximum value of VCs to 3 on the X.25 interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 vc-per-map 3
381
Advertisement
Table of Contents
