Bridge Routing - HP MSR series Command Reference Manual

Default command level
2: System level
Parameters
bridge-set: Specifies the bridge set number, an integer in the range of 1 to 255.
mac-address: Specifies the MAC address in the format of H-H-H.
deny: Discards frames whose source address or destination address is the specified address on all
interfaces or the specified interface.
permit: Forwards frames whose source address or destination address is the specified address on all
interfaces or the specified interface.
interface: Specifies an outbound interface.
interface-type interface-number: Specifies an interface by its name and number.
dlsw: Specifies that the outbound interface is a DLSw module.
Examples
# Configure a static bridge table entry so that Ethernet 1/1 can forward frames with a destination MAC
address of 0000-0000-01 1 1.
<Sysname> system-view
[Sysname] bridge 1 mac-address 0000-0000-0111 permit interface ethernet 1/1

bridge routing

Use bridge routing to enable routing of the specified protocols on the specified bridge set.
Use undo bridge routing to disable routing of the specified protocols on the specified bridge set.
Syntax
bridge bridge-set routing { ip | ipx }
undo bridge bridge-set routing { ip | ipx }
Default
Routing of network layer protocols is disabled.
Views
System view
Default command level
2: System level
Parameters
bridge-set: Specifies the bridge set number, an integer in the range of 1 to 255.
ip: Specifies the IP protocol.
ipx: Specifies the IPX protocol.
Usage guidelines
If the bridge set is configured to route the specified protocol, the packets of the protocol that need to be
routed are routed.
305