Ppp Authentication-Mode - HP MSR series Command Reference Manual

Use undo ppp acfc remote to restore the default.
Syntax
ppp acfc remote { apply | ignore | reject }
undo ppp acfc remote
Default
The device accepts ACFC requests received from a remote peer, but does not perform ACFC on frames
sent to the peer.
Views
Interface view
Default command level
2: System level
Parameters
apply: Configures the local end to accept ACFC requests received from the remote peer and to perform
ACFC on frames sent to the peer.
ignore: Configures the local end to accept ACFC requests received from the remote peer, but not to
perform ACFC on frames sent to the peer.
reject: Configures the local end to reject ACFC requests sent from the remote peer.
Examples
# Configure port Serial 2/0 to accept ACFC requests received from the remote peer and to perform
ACFC on frames sent to the peer.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ppp acfc remote apply

ppp authentication-mode

Use ppp authentication-mode to configure the PPP authentication mode.
Use undo ppp authentication-mode to disable PPP authentication.
Syntax
ppp authentication-mode { chap | ms-chap | ms-chap-v2 | pap } * [ [ call-in ] domain isp-name ]
undo ppp authentication-mode
Default
PPP authentication is disabled.
Views
Interface view
Default command level
2: System level
Parameters
chap: Uses CHAP authentication.
6