Mfr Retry - HP MSR series Command Reference Manual

Syntax
mfr link-name [ name ]
undo mfr link-name
Default
LID is the name of the physical interface.
Views
Frame relay interface view
Default command level
2: System level
Parameters
name: Name of a bundle link identification, which is a string of 1 to 49 characters.
Usage guidelines
Use link-protocol fr mfr to configure the current physical interface as a multilink frame relay bundle link
before using the mfr link-name command to configure.
The peer equipment identifies a frame relay bundle link through LID or associates the bundle link with a
frame relay bundle by using LID. The LIDs at both ends of a link can be the different.
The LIDs at both ends are used during the link bundle negotiation phase. After changing the bundle LID
on an interface, you must execute the shutdown and then undo shutdown commands on the interface to
make the new bundle LID take effect.
Examples
# Set the bundle LID of the multilink frame relay bundle link Serial 2/0 to be bl1.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr mfr 4
[Sysname-Serial2/0] mfr link-name bl1

mfr retry

Use mfr retry to set the maximum retry times for which a frame relay bundle link can resend hello
message when waiting for a hello acknowledgement message.
Use undo mfr retry to restore the default.
Syntax
mfr retry number
undo mfr retry
Default
The maximum retry times for which a frame relay bundle link can resend hello message is twice.
Views
Frame relay interface view
Default command level
2: System level
151