HP MSR series Command Reference Manual page 34

Usage guidelines
If you do not specify the mp-group keyword, this command displays information about interfaces on the
device.
If you specify the mp-group keyword without the mp-number argument, this command displays
information about all existing MP-group interfaces.
Examples
# Display detailed information about interface MP-group 12.
<Sysname> display interface mp-group 12
Mp-group12 current state: DOWN
Line protocol current state: DOWN
Description: Mp-group12 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet protocol processing : disabled
Link layer protocol is PPP
LCP initial
Physical is MP
Output queue : (Urgent queue : Size/Length/Discards)
Output queue : (Protocol queue : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards)
Last clearing of counters:
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
# Display brief information about interface MP-group12.
<Sysname> display interface mp-group 12 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
MP12
# Display brief information about all MP-group interfaces in DOWN state.
<Sysname> display interface mp-group brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
MP1
MP12
Table 1 Command output
Field
current state
Never
Link Protocol Main IP
DOWN DOWN --
Link Cause
ADM Administratively
DOWN Not connected
Description
Physical state of the interface:
•
•
•
0/50/0
0/75/0
Description
DOWN (Administratively)—The interface was shut down with the
shutdown command, that is, is administratively down.
DOWN—The interface is administratively up but physically down.
UP—The interface is both administratively and physically up.
22