Dlsw Ethernet-Frame-Filter; Dlsw Load-Balance - HP MSR series Command Reference Manual

<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] dlsw ethernet-backup enable 9999-9999-9999 priority 10
[Sysname-Ethernet1/1] dlsw ethernet-backup timer 1500

dlsw ethernet-frame-filter

Use dlsw ethernet-frame-filter to configure the DLSw router to filter Ethernet frames from or to the local
SNA device by applying the specified ACL for incoming or outgoing traffic.
Use undo dlsw ethernet-frame-filter to remove the ACL applied for the incoming or outgoing traffic.
Syntax
dlsw ethernet-frame-filter acl-number { inbound | outbound }
undo dlsw ethernet-frame-filter { inbound | outbound }
Views
System view
Default command level
2: System level
Parameters
acl-number: Layer 2 ACL number in the range of 4000 to 4999.
inbound: Applies the ACL to the incoming traffic.
outbound: Applies the ACL for the outgoing traffic.
Usage guidelines
For more information about a Layer 2 ACL, see ACL and QoS Command Reference.
Examples
# Apply ACL 4000 on the DLSw router to filter incoming Ethernet frames.
<Sysname> system-view
[Sysname] dlsw ethernet-frame-filter 4000 inbound

dlsw load-balance

Use dlsw load-balance to enable DLSw load balancing, and configure the default virtual circuit weight,
which is used by the remote peers that are not explicitly configured with the virtual circuit weight.
Use undo dlsw load-balance to disable DLSw load balancing.
Syntax
dlsw load-balance [ circuit-weight circuit-weight ]
undo dlsw load-balance
Views
System view
Default command level
2: System level
254