X25 Switching; X25 Timer Hold - HP MSR series Command Reference Manual

Usage guidelines
After configuring the XOT switching command of X.25 SVC, a user can cross IP network from the local
X.25 network to implement the interconnection with the remote X.25 network. If a user configures the
keepalive attribute, the link detection for XOT will be supported.
Examples
# Configure a XOT route and forward the packet whose destination X.121 address is 1 to the destination
address whose IP address is 10.1.1.1.
<Sysname> system-view
[Sysname] x25 switch svc 1 xot 10.1.1.1

x25 switching

Use x25 switching to enable the X.25 switching function.
Use undo x25 switching to disable this function, which will not affect the established virtual circuit
switching.
Syntax
x25 switching
undo x25 switching
Default
X.25 packet switching function is disabled.
Views
System view
Default command level
2: System level
Usage guidelines
X.25 packet switching accepts packets from an X.25 interface and sends them to a certain interface
based on the destination information contained in the packets. The device with this function can be used
as a small-sized packet switch.
Examples
# Enable X.25 switching function.
<Sysname> system-view
[Sysname] x25 switching

x25 timer hold

Use x25 timer hold to set the delay for sending another calling request to a destination to which a
previous request failed to reach.
Use undo x25 timer hold to restore the default.
Syntax
x25 timer hold minutes
undo x25 timer hold
376