Default command level
2: System level
Parameters
atm-class-name: Name of an ATM class, a string of 1 to 16 characters.
Examples
# Apply the ATM class named main to interface ATM 1/0.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] atm-class main
Related commands
atm class
atm-link check
Use atm-link check to adapt the protocol state of an ATM P2P subinterface to the status of the PVC on the
subinterface in addition to the status of the physical interface. The protocol state of the subinterface is up
only when both the physical interface and the PVC configured on the subinterface are up. If either of them
is down, the protocol state of the subinterface is down.
Use undo atm-link check to restore the default.
Syntax
atm-link check
undo atm-link check
Default
The protocol state of an ATM P2P subinterface is consistent with the status of the physical interface.
Views
ATM P2P subinterface view
Default command level
2: System level
Examples
# Adapt the protocol state of ATM P2P subinterface 4/0.1 to PVC status in addition to physical interface
status.
<Sysname> system-view
[Sysname] interface atm 4/0.1 p2p
[Sysname-Atm4/0.1] atm-link check
bandwidth
Use bandwidth to set the intended bandwidth for the interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
199