Ppp Compression Stac-Lzs; Ppp Mp Lfi - HP MSR series Command Reference Manual

Examples
# Set the maximum number of connections allowed by TCP compression to 10 on interface serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ppp compression iphc tcp-connections 10

ppp compression stac-lzs

Use ppp compression stac-lzs to enable Stac LZS compression on an interface.
Use undo ppp compression stac-lzs to disable Stac LZS compression.
Syntax
ppp compression stac-lzs
undo ppp compression stac-lzs
Default
Stac LZS compression is disabled.
Views
Interface view
Default command level
2: System level
Usage guidelines
Stac LZS compression is supported on the current version of system. Stac LZS compression is lossless.
However, as this can increase the load on the device, do not enable Stac LZS compression when the
device is busy.
Stac LZS compression takes effect on a PPP link only when it is enabled on both sides of the link.
Outbound expedite forwarding is not available on links with Stac LZS compression enabled. Disable
outbound expedite forwarding before executing the ppp compression stac-lzs command.
After you enable Stac LZS compression on a VT and Dialer interface, or ISDN interface, you must shut
down and then bring up the interface for the configuration to take effect.
If the configuration is applied on a MP bundle, you must shut down and then bring up all the MP member
interfaces for the configuration to take effect.
Examples
# Enable Stac LZS compression on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ppp compression stac-lzs

ppp mp lfi

Use ppp mp lfi to enable LFI on an interface.
Use undo ppp mp lfi to disable LFI.
48