Ppp Mp Short-Sequence - HP MSR series Command Reference Manual

Parameters
mp-number: MP-group interface by its number in the range of 0 to 1023.
Usage guidelines
This command should be used together with the interface mp-group command. However, the order in
which the two commands are executed can be either one. You can create an MP-group interface and
then add an interface to the MP-group; or add the interface to the MP-group and then create the
MP-group.
You can add only physical interfaces to an MP group. Logical interfaces (such as Tunnel interfaces) do
not support the ppp mp mp-group command.
Examples
# Add interface Serial 2/0 to MP-group 3.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ppp mp mp-group 3

ppp mp short-sequence

Use ppp mp short-sequence to trigger MP short sequence number header format negotiation. After the
negotiation succeeds, the local end receives packets with short sequence numbers.
Use undo ppp mp short-sequence to restore the default.
Syntax
ppp mp short-sequence
undo ppp mp short-sequence
Default
The long sequence number header format is used.
Views
Interface view
Default command level
2: System level
Usage guidelines
This command applies to the incoming direction only. To enable the local end to transmit packets with
short sequence numbers, configure the remote end to receive packets with short sequence numbers.
The sequence number format (long or short) of an MP bundle depends on the configuration of the first
channel joining the MP bundle.
To negotiate the use of short sequence numbers on a dialer MP bundle, configure the command on the
dialer interfaces and the ISDN D channels; to do that on a common MP bundle, use the command on all
its channels. The command will cause PPP re-negotiation.
Examples
# Configure the short sequence number header format of MP in the incoming direction of interface Serial
2/0.
<Sysname> system-view
36