Dialer Flow-Interval; Dialer Isdn-Leased (Physical Interface View) - HP MSR series Command Reference Manual

After you disable C-DCC, the system clears all configurations on dialup interfaces. To recover the dialer
interfaces, you must re-enable them by using the shutdown command and then the undo shutdown
command. If you use the dialer enable-circular command or its undo form on a non-dialup interface, do
the same on the interface to recover it.
Examples
# Enable C-DCC on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] dialer enable-circular
Related commands
dialer circular-group

dialer flow-interval

Use dialer flow-interval to set the interval for DCC to collect traffic statistics.
Use undo dialer flow-interval to restore the default.
Syntax
dialer flow-interval interval
undo dialer flow-interval
Default
The interval for DCC to collect traffic statistics is 20 seconds.
Views
System view
Default command level
2: System level
Parameters
interval: Specifies the interval for DCC to collect traffic statistics, in the range of 1 to 1500 seconds.
Usage guidelines
This command is only useful for traffic-triggered dial in DCC. For example, when using traffic-triggered
MP link bundling with DCC, you must configure DCC to send traffic statistics about dialup links at certain
intervals to MP.
Examples
# Set the interval for DCC to collect traffic statistics to 3 seconds.
<Sysname> system-view
[Sysname] dialer flow-interval 3
Related commands
dialer threshold

dialer isdn-leased (physical interface view)

Use dialer isdn-leased to configure an ISDN B channel for leased line connection.
168