Bridging Configuration Commands; Bandwidth; Bridge Aging-Time - HP MSR series Command Reference Manual

Bridging configuration commands

If no Ethernet interfaces are assigned to the bridge set corresponding to the bridge-template interface, a
bridge-template interface uses its default MAC address: 000f-e207-f301 for bridge-template 1;
000f-e207-f302 for bridge-template 2; ...; 000f-e207-f3ff for bridge-template 255.

bandwidth

Use bandwidth to set the intended bandwidth for a bridge-template interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
Bridge-template interface view
Default command level
2: System level
Parameters
bandwidth-value: Specifies the intended bandwidth in the range of 1 to 4294967295 kbps.
Usage guidelines
You can get the intended bandwidth of an interface by using third-party software to query the value of
the MIB ifspeed.
The intended bandwidth of an interface is for the network management system to monitor the interface
bandwidth. It does not affect the actual bandwidth of the interface.
Examples
# Set the intended bandwidth to 1000 kbps for interface Bridge-template 1.
<Sysname> system-view
[Sysname] interface bridge-template 1
[Sysname-Bridge-template1] bandwidth 1000

bridge aging-time

Use bridge aging-time to configure the aging time of dynamic bridge table entries.
Use undo bridge aging-time to restore the default setting.
Syntax
bridge aging-time seconds
undo bridge aging-time
301