X25 Timer Tx0 - HP MSR series Command Reference Manual

The x25 timer idle command applies to all the SVCs under the interface. You can also use the options in
the x25 map command to configure the maximum idle time for the SVC related to the address mapping
and the priority is higher than the configuration of the interface.
If the value is set to 0, this SVC will be reserved no matter how long it stays idle.
Using this command does not work for PVC or the established SVC of X.25 switching.
Examples
# Set the maximum idle time of the SVC to 10 minutes on the interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer idle 10
Related commands
x25 map

x25 timer tx0

Use x25 timer tx0 to set the restart timer for DTE (or DCE).
Use undo x25 timer tx0 to restore the default.
Syntax
x25 timer tx0 seconds
undo x25 timer tx0
Default
The restart timer on the X.25 DTE is 180 seconds and that on the DCE is 60 seconds.
Views
Interface view
Default command level
2: System level
Parameters
seconds: X.25 restart timer in seconds. It ranges 1 to 1000.
Usage guidelines
According to X.25, a timer should be started when the DTE sends a restart request (or a DCE sends a
restart indication). If no peer acknowledgement is received after the timer timeout, the sending end will
take some measures to guarantee the normal proceeding of the local procedure. This parameter
specifies the time of this timer.
Examples
# Set the restart timer to 120 seconds on the X.25 interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer tx0 120
Related commands
x25 timer tx1
•
378