X25 Receive-Threshold - HP MSR series Command Reference Manual

Use undo x25 queue-length to restore the default.
Syntax
x25 queue-length queue-length
undo x25 queue-length
Default
The data queue length for X.25 virtual circuits is 200.
Views
Interface view
Default command level
2: System level
Parameters
queue-length: Queue length in packets, in the range of 0 to 9999. The queue-length argument of 0
indicates sending no packets.
Usage guidelines
When the data traffic is too heavy, you can use this command to extend the receiving queue and sending
queue of X.25 virtual circuits to avoid data loss that affects transmission performance. Modifying this
parameter would not affect the existing data queue of virtual circuits. After changing the parameter, you
must restart the port with the shutdown command and then the undo shutdown command and this will
clear the current SVCs and reset the PVCs, and change the data queue of all the VCs.
Examples
# Set the queue length for virtual circuits on X.25 interface Serial 2/0 to 75 packets.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 queue-length 75

x25 receive-threshold

Use x25 receive-threshold to set the maximum number of packets that can be received before X.25 sends
an acknowledgement packet.
Use undo x25 receive-threshold to restore the default.
Syntax
x25 receive-threshold count
undo x25 receive-threshold
Default
The value is 0, and the acknowledgement threshold is disabled.
Views
Interface view
Default command level
2: System level
365