Timer Hold - HP MSR series Command Reference Manual
Layer 2 wan
Hide thumbs
Also See for MSR series:
- Configuration manual (889 pages) ,
- Command reference manual (684 pages) ,
- Wan access configuration manual (293 pages)
Table of Contents
Advertisement
Default
The switching PVC is enabled.
Views
Frame relay switching view
Default command level
2: System level
Examples
# Create a PVC named pvc1 on the DCE serving as the switch, which is from the DLCI 100 of Serial 2/0
to the DLCI 200 of Serial 2/1 and then shut down the PVC.
<Sysname> system-view
[Sysname] fr switching
[Sysname] fr switch pvc1 interface serial 2/0 dlci 100 interface serial 2/1 dlci 200
[Sysname-fr-switching-pvc1] shutdown
timer hold
Use timer hold to configure T391 parameter at the DTE side.
Use undo timer hold to restore the default.
Syntax
timer hold seconds
undo timer hold
Default
The parameter is 10 seconds.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Value of T391 parameter at DTE side, which is in the range of 0 to 32767 in seconds. 0
indicates that the LMI protocol is disabled.
Usage guidelines
The parameter is a time variable that defines the interval at which the DTE sends Status-Enquiry
messages.
Examples
# Configure that frame relay interface Serial 2/0 to operate in DTE mode, and set the value of T391
parameter to 15 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr
[Sysname-Serial2/0] fr interface-type dte
[Sysname-Serial2/0] timer hold 15
133
Advertisement
Table of Contents
