Peer Neighbor-Route; Ppp Pap Local-User - HP MSR series Command Reference Manual

If PPP LQC is not enabled, each end of a PPP link sends keepalive packets to its peer periodically. After
you enable PPP LQC, LQR packets replace keepalive packets to monitor the link.
With PPP LQC enabled, the system determines the link quality by processing LQR packets received and
disables the link if two successive link quality samples are below the PPP LQC close-percentage. After a
PPP link is disabled by PPP LQC, the system samples the link quality once in each period ten times of LQR
packet sending intervals, and enables the link up if three successive link quality samples are higher than
the PPP LQC resume-percentage. A disabled link must experience at least 30 keepalive periods before it
can be enabled again. Therefore, make sure the keepalive period is proper in order that PPP links can be
enabled timely.
For a PPP link with PPP LQC enabled on both sides, the PPP LQC settings of the both sides must be the
same. HP recommends that you not enable PPP LQC on both sides of a PPP link.
Because DCC tears down a dial-up line when the link established on the line is disabled, PPP LQC cannot
operate correctly on dial-up lines. Thus, it is not recommended on dial-up links.
Examples
# Enable PPP LQC on interface Serial 2/0, setting the PPP LQC close-percentage to 90 and
resume-percentage to 95.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ppp lqc 90 95

peer neighbor-route

Use peer neighbor-route to enable peer route creation.
Use undo peer neighbor-route to disable peer route creation.
Syntax
peer neighbor-route
undo peer neighbor-route
Default
Peer route creation is enabled.
Views
Serial interface view, AUX interface view, AM interface view, cellular interface view, ISDN BRI interface
view, POS interface view, dialer interface view, VT interface view
Default command level
2: System level
Examples
# Disable peer route creation on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-serial2/0] undo peer neighbor-route

ppp pap local-user

Use ppp pap local-user to set the local username and password for PAP authentication.
13