HP MSR series Command Reference Manual page 196

# Display brief information about all Dialer interfaces in DOWN state.
<Sysname> display interface dialer brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
Dia1
Table 34 Command output
Field
current state
Line protocol current state
Description
The Maximum Transmit Unit
Internet protocol processing
Link layer protocol is PPP
LCP initial
Physical is Dialer
Output queue : (Urgent queuing :
Length)
Output queue : (Protocol
queuing : Length)
Output queue : (FIFO queuing :
Length)
Last clearing of counters: Never
Last 300 seconds input rate
Last 300 seconds output rate
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0
drops
The brief information of
interface(s) under route mode
Link: ADM - administratively
down; Stby - standby
Link Cause
ADM Administratively
Description
Physical state of a dialer interface:
•
UP—The dialer interface is physically up.
•
DOWN (Administratively)—The dialer interface was shut down with the
shutdown command. To re-enable it, you must run the undo shutdown
command on it.
Data link layer protocol state of the dialer interface (up/down).
Interface description.
MTU of the dialer interface.
Network layer protocol state of the dialer interface (enabled/disabled).
Current data link layer protocol.
LCP is initialized.
The physical interface is a dialer interface.
Statistics on the packets in the urgent output queue.
Statistics on the packets in the protocol output queue.
Statistics on the packets in the FIFO output queue.
Time when statistics on the dialer interfaces were last cleared. Never
indicates the statistics were never cleared.
Input interface data rate during the latest 300 seconds.
Output interface data rate during the latest 300 seconds.
Statistics on the packets reaching the interface.
Statistics on the packets sent through the interface.
Brief information about Layer 3 interfaces.
Link status:
•
ADM—The interface has been administratively shut down. To recover its
physical state, perform the undo shutdown command.
•
Stby—The interface is operating as a backup interface. To see the
primary interface, use the display standby state command (High
Availability Command Reference).
184