Dialer Disconnect; Dialer Enable-Circular - HP MSR series Command Reference Manual
Layer 2 wan
Hide thumbs
Also See for MSR series:
- Configuration manual (889 pages) ,
- Command reference manual (684 pages) ,
- Wan access configuration manual (293 pages)
Table of Contents
Advertisement
[Sysname-Serial2/1] dialer circular-group 1
Related commands
interface dialer
dialer disconnect
Use dialer disconnect to clear the dialup link on an interface or all dialup links if no interface is specified.
Syntax
dialer disconnect [ interface interface-type interface-number ]
Views
Any view
Default command level
1: Monitor level
Parameters
interface interface-type interface-number: Disconnects the dialup link on an interface specified by its
type and number.
Examples
# Clear the dialup link on interface Dialer 0.
<Sysname> dialer disconnect interface dialer0
dialer enable-circular
Use dialer enable-circular to enable C-DCC.
Use undo dialer enable-circular to disable C-DCC.
Syntax
dialer enable-circular
undo dialer enable-circular
Default
C-DCC is not enabled on an interface.
Views
Dialup interface (physical or dialer interface) view
Default command level
2: System level
Usage guidelines
You must enable C-DCC before you can use it.
To use RS-DCC on a dialer interface, you must configure the dialer user command and the dialer bundle
command on the dialer interface, and assign physical interfaces to the dialer bundle with the dialer
bundle-member command.
167
Advertisement
Table of Contents
