Interface Dialer - HP MSR series Command Reference Manual

Field
Protocol: (s) - spoofing
Interface
Link
Protocol
Main IP
Description
Cause

interface dialer

Use interface dialer to create a dialer interface. In C-DCC, this equals creating a dialer circular group.
Use undo interface dialer to remove a dialer interface.
Syntax
interface dialer number
undo interface dialer number
Default
No dialer interface is created.
Views
System view
Default command level
2: System level
Parameters
number: Dialer interface number in the range of 0 to 1023.
Usage guidelines
The dialer interface has a fixed baudrate of 64000 bps.
In C-DCC, you can assign multiple physical interfaces to a dialer interface to inherit the attributes of this
dialer interface by assigning them to the dialer circular group for the dialer interface with the dialer
circular-group command. This is efficient where calling multiple destinations simultaneously is desired,
because instead of configuring individual physical interfaces, you only must configure multiple dialer
routes on the dialer interface.
In RS-DCC, any dialer interface can use the services provided by multiple physical interfaces, and
individual physical interfaces can provide services for multiple dialer interfaces at the same time.
Description
If the network layer protocol state of an interface is shown as UP, but its link
is an on-demand link or not present at all, its protocol attribute includes the
spoofing flag (an s in parentheses).
Abbreviated interface name.
Physical link state of the interface:
•
UP—The link is up.
•
ADM—The link has been administratively shut down. To recover its
physical state, perform the undo shutdown command.
Protocol connection state of the interface: UP, DOWN, or UP(s).
Main IP address of the interface.
Description of the interface.
Cause of a DOWN physical link. If the port has been shut down with the
shutdown command, this field displays Administratively. To restore the
physical state of the interface, use the undo shutdown command.
185