Dlsw Timer - HP MSR series Command Reference Manual

Default
The multicast function of DLSw v2.0 is disabled.
Views
System view
Default command level
2: System level
Parameters
multicast-ip-address: Multicast IP address in the range of 224.0.10.0 to 224.0.10.191. The default is to
224.0.10.0.
interface: Specifies the interface through which DLSw v2.0 multicasts are sent.
interface-type interface-number: Specifies an interface by its type and number.
Examples
# Enable the router to send DLSw 2.0 multicasts to the multicast address of 224.0.10.10 through Ethernet
1/0.
<Sysname> system-view
[Sysname] dlsw multicast 224.0.10.10 interface ethernet 1/0
Related commands
• dlsw enable
igmp enable (IP Multicast Command Reference)
•
• pim dm (IP Multicast Command Reference)
pim sm (IP Multicast Command Reference)
•

dlsw timer

Use dlsw timer to configure DLSw timers.
Use undo dlsw timer to restore DLSw timers to the default settings.
Syntax
dlsw timer { cache | connected | explorer | explorer-wait | local-pending | remote-pending } seconds
undo dlsw timer { cache | connected | explorer | explorer-wait | local-pending | remote-pending }
Views
System view
Default command level
2: System level
Parameters
cache seconds: Timeout period of addresses in SNA cache, in seconds. The range is 1 to 65535, and the
default is 120 seconds.
connected seconds: Connection timeout period in seconds. The range is 1 to 65535, and the default is
300 seconds.
261