Dialer Circular-Group - HP MSR series Command Reference Manual

dial-number configured in the dialer route or dialer number command is the same as the remote-number
configured in the dialer call-in command.
Examples
# Configure the device to place return calls for ISDN calling number 8810152.
<Sysname> system-view
[Sysname] interface bri 1/0
[Sysname-Bri1/0] dialer route ip 100.1.1.2 8810152
[Sysname-Bri1/0] dialer call-in 8810152 callback
Related commands
dialer callback-center

dialer circular-group

Use dialer circular-group to assign the physical interface to a dialer circular group in the C-DCC
approach.
Use undo dialer circular-group to remove the interface from the dialer circular group.
Syntax
dialer circular-group number
undo dialer circular-group
Default
A dialer circular group does not include any physical interfaces.
Views
Dialup interface (physical interface) view
Default command level
2: System level
Parameters
number: Specifies the number of a dialer circular group, the same as the one defined in the interface
dialer command. The value range for this argument is 0 to 1023.
Usage guidelines
In C-DCC, you can assign a physical interface to a dialer interface by assigning it to the dialer circular
group associated with the dialer interface. A physical interface can belong to only one dialer interface,
but a dialer interface includes all physical interfaces assigned to its associated dialer circular group.
When placing a call on the dialer interface, DCC selects the physical interface with a higher priority.
Examples
# Add interface Serial 2/0 and Serial 2/1 to dialer circular group 1.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] quit
[Sysname] interface serial 2/0
[Sysname-Serial2/0] dialer circular-group 1
[Sysname-Serial2/0] quit
[Sysname] interface serial 2/1
166