Translate Ip - HP MSR series Command Reference Manual

Parameters
local-ip-address: Local IP address of the XOT connection.
local-port: Local port number of the XOT connection.
remote-ip-address: Remote IP address of the XOT connection.
remote-port: Remote port number of the XOT connection.
Usage guidelines
When you clear or reset the XOT link, you can obtain the required ports using the display x25 xot or
display tcp status command.
Examples
# Clear or reset the XOT connection.
<Sysname> reset xot local 10.1.1.1 1998 remote 10.1.1.2 1024

translate ip

Use translate ip to configure an X2T forwarding route from IP network to X.25 network.
Use undo translate ip to remove the route.
Syntax
translate ip ip-address port port-number { pvc interface-type interface-number pvc-number | x25
x.121-address }
undo translate ip ip-address port port-number
Views
System view
Default command level
2: System level
Parameters
ip-address: Local IP address.
port port-number: Specifies the TCP port number on which the local router listen messages, in the range
1 to 65535.
interface-type interface-number: Type and number of an interface.
pvc-number: PVC number, in the range 1 to 4095.
x25 x.121-address: Specifies an X.121 address.
Usage guidelines
When a host in the IP network sends packets to the specified IP address and port number of the device,
the device will translate these IP packets to X.25 ones and then forward them to the specified X.121
address or PVC in the X.25 network.
The maximum number of IP-to-X.25 mappings is 32.
For the translate ip command, if an IP address uses only one port number, port number 102 is preferred
whenever possible. If an IP address uses multiple port numbers, port numbers between 1024 and 5000
are recommended and the well-known port numbers (such as 21, 23) are not used to avoid network
failure.
349