Interface Bridge-Template - HP MSR series Command Reference Manual

Use undo fr map bridge to remove an FR-to-bridging mapping.
Syntax
fr map bridge dlci broadcast
undo fr map bridge dlci
Default
No FR-to-bridging mappings exist.
Views
Interface view
Default command level
2: System level
Parameters
dlci: Specifies the local virtual circuit number in the range of 16 to 1007.
broadcast: Specifies to allow bridging of broadcasts over this FR-to-bridging mapping.
Examples
# Create an FR-to-bridging mapping on the virtual circuit by the DLCI of 50 on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr
[Sysname-Serial2/0] fr interface-type dce
[Sysname-Serial2/0] fr dlci 50
[Sysname-Serial2/0] bridge-set 1
[Sysname-Serial2/0] fr map bridge 50 broadcast
Related commands
display fr map-info

interface bridge-template

Use interface bridge-template to create a bridge-template interface for a bridge set.
Use undo interface bridge-template to remove a bridge-template interface.
Syntax
interface bridge-template bridge-set
undo interface bridge-template bridge-set
Views
System view
Default command level
2: System level
Parameters
bridge-set: Specifies the bridge set number, an integer in the range of 1 to 255.
316