Isdn Ignore Sending-Complete - HP MSR series Command Reference Manual

Usage guidelines
In the event that the router is communicating with an ISDN switch, its settings must be the same as those
on the switch.
You are not allowed to configure this command on an ISDN interface if a call still exists on it. This
command can take effect only if it is configured when no call exists on the interface. Alternatively, you
can manually disable the interface by executing the shutdown command, configure the command, and
then enable the interface by executing the undo shutdown command. The operations, however, will lead
to the disconnection of the call existing on the interface.
Examples
# Disable ISDN from carrying the LLC information element in the SETUP messages for the voice calls
placed on interface BRI 2/0.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn ignore llc

isdn ignore sending-complete

Use isdn ignore sending-complete to configure the ISDN protocol to ignore the Sending Complete
Information Element in Setup messages when receiving a call, or to send Setup messages without the
Sending Complete Information Element when placing a call.
Use undo isdn ignore sending-complete to restore the default setting.
Syntax
isdn ignore sending-complete [ incoming | outgoing ]
undo isdn ignore sending-complete [ incoming | outgoing ]
Views
ISDN interface view
Default command level
2: System level
Parameters
incoming: Ignores the Sending Complete Information Element in Setup messages when receiving a call.
outgoing: Sends Setup messages without the Sending Complete Information Element when placing a
call.
Usage guidelines
As for the data exchange performed between a router and an ISDN switch, the default is as follows.
For an incoming call, the router checks the received Setup messages for the Sending Complete
•
Information Element to determine whether or not the number is received completely. If a Setup
message does contain the Sending Complete Information Element, the number is not received
completely.
For an outgoing call, a Setup message containing the Sending Complete Information Element
•
indicates that the number is sent completely.
83