Fr Lmi N392Dce - HP MSR series Command Reference Manual

Default
The full link status polling interval is 6.
Views
Interface view
Default command level
2: System level
Parameters
n391-value: Value of counter N391 in the range of 1 to 255.
Usage guidelines
The DTE sends a Status-Enquiry message at a regular interval set by T391 to the DCE. The Status-Enquiry
messages include the following types: link integrity verification messages and full link status enquiry
messages. N391 defines that the ratio of sent link integrity verification messages to sent link
Status-Enquiry messages is (N391–1):1.
Examples
# Set DTE as the operating mode of frame relay interface Serial 2/0, and the counter value of the PVC
status to 10.
<Sysname> system-view
[Sysname] interface serial2/0
[Sysname-Serial2/0] link-protocol fr
[Sysname-Serial2/0] fr interface-type dte
[Sysname-Serial2/0] fr lmi n391dte 10

fr lmi n392dce

Use fr lmi n392dce to set the N392 counter at the DCE side.
Use undo fr lmi n392dce to restore the default.
Syntax
fr lmi n392dce n392-value
undo fr lmi n392dce
Default
The DCE-side N392 counter is 3.
Views
Interface view
Default command level
2: System level
Parameters
n392-value: Sets the DCE-side error threshold in the range of 1 to 10.
Usage guidelines
The DCE requires the DTE to send a Status-Enquiry message at a regular interval (set by T392). If the DCE
does not receive the Status-Enquiry message within a certain period, the error counter on the DCE
122