Isdn Check-Time; Isdn Crlength - HP MSR series Command Reference Manual

called-party-number: Called number, a string of 1 to 20 digits.
subaddress: Subaddress, which is a string of 1 to 20 digits, case-insensitive English letters, or both.
Usage guidelines
This command is used for setting the examined item when a digital call is received. If a subaddress is
specified, the system will deny an incoming digital call if the calling party sends a wrong subaddress or
does not send at all.
Examples
# Check whether the called number carried by incoming digital calls is 66668888 on interface BRI 2/0.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn check-called-number 1 66668888

isdn check-time

Use isdn check-time to enable ISDN call check and set the time to start ISDN call check.
Use undo isdn check-time to restore the default.
Syntax
isdn check-time date-time
undo isdn check-time
Default
ISDN call check is disabled.
Views
System view
Default command level
2: System level
Parameters
date-time: Specifies the time (in the format hh:mm) to start ISDN call check.
Usage guidelines
ISDN call check examines the call control block synchronization status between the CC module and the
Q.931 module for ISDN calls every day at the specified time. If the call control blocks of the two modules
for an ISDN call are not synchronized, the system disconnects the ISDN call.
Examples
# Enable the system to perform ISDN call check every day at 08:30.
<Sysname> system-view
[Sysname] isdn check-time 8:30

isdn crlength

Use isdn crlength to set length of the call reference used when a call is placed on an ISDN interface.
Use undo isdn crlength to restore the default ISDN call reference length on the interface.
79